This authentic vintage-style Fender Telecaster neck is made in our factory in Ensenada, Mexico. It features a very comfortable "Vintage C" profile and a 7.25 "(184mm) radius maple fingerboard with 21 vintage-style frets. The synthetic bone nut is pre-cut; these" pilot "grooves make string spacing easier during final filing. Finally, a varnished finish provides a vintage feel. This replacement neck is the perfect solution to bringing your Tele back to the authentic feel of 1950s models.
This replacement neck is compatible with Fender or Squier by Fender models.
Replacement Fender shafts have never been attached to instrument bodies, so the nut grooves must be trimmed by qualified personnel. Additional installation procedures may be required, such as shrinking, inserting the handle into the cavity, and other instrument setup steps. You can have your replacement handle installed at your local FMIC Approved Maintenance Center. You can find the addresses of
Authorized Service Centers near you in the "Support" section of fender.com.
Radius : 7.25" (184.1 mm)
Refinement Fingerboard Radius : Vintage
Frets syze : Vintage
Neck material : Maple
Refinement Neck Material : Maple
Neck profil : Vintage "C"
Refinement Neck Shape : C Shape
Frets : 21
Nut Material : Synthetic Bone
Nut width : 1.650" (42 mm)
Scale : 25.5" (648 mm)
Truss rod : Vintage-Style Heel Adjust
Truss Rod Nut : Vintage-Style Slotted
Neck Thickness : 1st Fret - .860" (21.84 mm), 12th Fret - .919" (23.34 mm)
Neck Mounting : 4-Bolt
Tuner Mounting Config : Vintage-Style 2-Screw
Instrument Type : Telecaster
Peg Hole Diameter : .358" (9.09 mm)
Headstock Thickness : .540" (13.71 mm)
Style : Vintage-Style
Where Used : Classic Series