The circuit designed by Mr Neve makes it possible to capture high frequencies with a very high level of detail, up to 25 kHz, or 3 times the bandwidth of a conventional ribbon microphone. In addition, the input and output transformers designed by Mr. Neve and wound by hand make it possible to obtain enormous headroom and reduce the noise level. The faithful reproduction of harmonics over the entire bandwidth makes it possible to truly capture the "true" sound of the source, which makes the RNR1 a microphone with revolutionary status and an exemplary reputation.
Features - Operating principle: electrodynamic pressure gradient with active electronics - Nature of the transducer: aluminum tape 2.5 µm thick, hand-stretched - Directivity: bi-directional (figure 8) - Frequency response: 20Hz - 25,000Hz - Sensitivity: 22.39mV/Pa (-33dB) - Max SPL: 135dB (0.5% THD @ 1kHz) - Equivalent noise level (weighted): 15 dB(A) - Signal-to-noise ratio: 76dB - Own noise: 18 dB(A) - Impedance: 200 Ohms - Recommended load impedance: 1 kOhm - Low-cut filter switch: 100 Hz - Connector: 3-point female XLR - Power supply: 48 V phantom - Weight: 860g