18" active subwoofer ICOA SUB 18 4
The groove is assured with penetrating bass. The ICOA SUB subwoofer allows you to adjust them to the desired level to put the audience in the right place. atmosphere and attract it to the dance floor or to emphasize the message to be transmitted during a conference.
The ICOA SUB subwoofer is very efficient in the low end of the audio spectrum while offering Generous power reserves and very clear sound reproduction It in fact relieves the main speaker, whose woofers will be less constrained by bass impulses, resulting in reduced intermodulation distortions: even at high volume, the sound of the bass. voice and instruments remain perfectly clear.
Its 600 W (RMS) class D amplifier offers a peak power of 2400 W. So it has something under the hood. You can also ideally adapt it. ICOA SUB to your installation, via the integrated DSP DynX presets. It also offers three cutoff frequencies to choose from: 80, 100 and 120 Hz. Finally, the polarity of the signal can be changed and the Line Delay can be adjusted up to 10. m.
If requirements change over time and rooms become larger and larger, the installation adapts. It is in fact possible to mount several ICOA SUB subwoofers in parallel. This will give you even more power. With two ICOA SUBs you can also use the cardioid mode. Normally, the subwoofer emits in all directions. By pointing one toward the rear and activating the pre-configured cardioid mode, the bass will be delivered forward in a controlled manner, while maintaining the same punch.
These 18" laminated wood subwoofers mm are stackable and have an M20 thread on the top allowing the main speaker to be mounted with a spacer bar. For transport, casters can be fitted at the rear; pads protect the edge during assembly and disassembly operations. Finally, to ensure that the ICOA SUB subwoofer fits comfortably in the hand, four aluminum handles with rubberized surfaces are available.
DJs, singer-songwriters, rock groups or dance orchestras: the ICOA SUB is the ideal solution for amplifying live bass, but also for conferences and multimedia presentations. With clear sound and crisp bass, the result is grandiose in all circumstances!
- 18" subwoofer impressive in the low end of the audio spectrum up to 29 Hz
- Max. SPL of 133 dB and PEAK power of 2400 W thanks to a class D digital amplifier
- Optimized Bass Reflex openings
- DSP DynX with 4 presets (3 crossover frequencies, cardioid mode)
- Modifiable signal polarity and Line Delay adjustable up to 10 m
- 2 combined inputs (jack/XLR), 2 XLR outputs
- Solid 18 mm plywood housing with resistant front grille
- Easy handling thanks to 4 aluminum handles with ergonomic rubberized surface
- Ideal stacking capacity thanks to 4 notches stacking
- M20 thread for mounting a spreader bar
Technical Characteristics
- Product type: PA subwoofer
- Type: Active
- Boomer/midrange diameter: 18 "
- Boomer diameter: 457.2 m
< li class="left-item">Boomer magnet: Ferrite- Boomer brand: Customized
- Coil woofer: 4 "
- Boomer coil (mm): 100 mm
- Amplifier: Class D
- Power (effective): 600 W
- Power (peak): 2400 W
- Response frequency (-10dB): 29Hz Preset dependent
- Maximum SPL (peak): 133 dB
- Protection circuits: limiter activation, Excursion Limiter, Overload, Overheating, Overvoltage
- Settings: encoder/key
- Indicators: LC Display
- Line Inputs: 2
- Line Input Connectors : XLR/6.3mm jack combo jacks (balanced)
- Line outputs: 2
- Line output connectors : XLR
- Main voltage: 100 - 240 V
- Power consumption (max): 675 W
- Use temperature: 0 - 40 °C
- Relative humidity rate: < 60%, non-condensing< /li>
- Case material: 18 mm Multiplex
- Case surface: Structured lacquer paint
- Case finish: Bass Reflex
- Width: 626 mm
- Height (mm ): 672 mm
- Depth: 637 mm
- Weight: 44.3 kg
en 
