Customize your tone with the Pre-Wired Stratocaster pickguards. Made with premium components in the same factory as our iconic guitars, this pickguard is easy to install. Simply remove the old pickguard, solder the output jack and ground wires, screw on the new pickguard, and you’re ready to play with pure Fender tone. With a slightly hotter output than typical vintage pickups and a powerful magnet combination, these powerful and highly dynamic pickups deliver the perfect balance between clean and dirty rhythm and lead sounds to satisfy players of all levels, through any amplifier. The neck pickup is based on a ’54 Strat pickup with oversized Alnico 3 magnets. The middle pickup, based on a ’63 Strat pickup, uses specially treated Alnico magnets and is reverse-wound to cancel hum when used with the neck or bridge pickup. The bridge pickup uses Alnico 5 magnets and is specially designed to be hotter without sacrificing high-end sparkle.
FEATURES
HARDWARE
PICKGUARD: 1-Ply Parchment
PICKGUARD PLY: 1-Ply
PICKUP COVERS: Aged White
CONTROL KNOBS: Aged White
PICKUP SELECTOR TIP: Aged White
HARDWARE FINISH: Chrome
ELECTRONICS
BRIDGE PICKUP: Custom Eric Johnson Signature Stratocaster Bridge Pickup
MIDDLE PICKUP: Custom Eric Johnson Signature Stratocaster RWRP Middle Pickup
NECK PICKUP: Custom Eric Johnson Signature Stratocaster Neck Pickup
PICKUP CONFIGURATION: SSS
CONNECTOR WIRE: Cloth-covered
MAGNET TYPE: Neck and Middle: Alnico 3, Bridge: Alnico 5
COIL WIRE: Formvar-coated
POLES: Staggered
COIL MATERIAL: Fiber
CONTROLS: Master Volume, Tone 1 (Neck Pickup), Tone 2 (Bridge Pickup)
OUTPUT: Vintage
DC RESISTANCE: Neck: 5.8-6k, Middle: 6.3-6.5k, Bridge: 6.7-6.9k
en 
